Project 2 comprises the following exercises:
Project 2: Casting the internal surface of a vessel
24th July 2016Written by dtomkiesocammt
Project 2: Casting the internal surface of a vessel
Similar posts
Project 2: Collatype printing – Exercise 3 – Collatype collage prints
7th May 2017For this exercise I was keen to take on board the points for success as identified in Exercises One and Two. The key challenge for me was to select good images that would lend themselves well to interpretation in a collage print. I selected the following images and added for the fourth an interpretation of […]
Project 2: Collatype printing – Exercise 2 – Polyfilla block
7th May 2017For this exercise I used Polyfilla to create the block as recommended and used a variety of materials to mark the block for printing. First impressions were that the range of marks was good and should produce a print with lots of variety and interest. However, I did note that it was much more difficult […]
Project 2: Collatype printing – Exercise 1 – Create a collage block
7th May 2017For this exercise I raided the cupboards and pantry for items that seemed would produce an interesting print. These were arranged on the cardboard ‘block’ and pva used to seal and glue in place. The items used to print from were: Top left to right: Scrumpled plastic, wire bread ties, toothpicks, drawing pins, string Lower […]